Peter Pepper Recessed Lighting - Low Voltage LED Lighting for Display Cases

Peter Pepper's LED lighting system is designed for recessed mounting.  Soffit areas conceal the transformer and fixtures in the top or bottom area of the display case.  LED lighting provides brighter, whiter light that gives extraordinary brilliance to the merchandise.

Mounting

The LED fixtures are equally spaced and recessed into the top inside panel of the display area. The trim ring is 2-3/4" in diameter and extends 1/4" below the finished panel. The top inside panel finish is black.

The transformer is remotely mounted in the soffit area. A 10´ power cord exits at the top rear panel of the soffit on models ESW-S, PMW-S, MMW-S and REW-S.  On models PMS-E, ESZ, ESZ-B, US, USZ and USZ-B, the cord exits at the bottom of the case.  Recessed lighting is not available on Model US with a Spacer Top.

Finish

The standard finish is Black. The fixture housings and trim rings are made of high temperature polycarbonate injection molded resin. 

The reflector system is made of high-grade aluminum, bright-dipped and anodized for maximum performance. 

Trim rings have a 3mm thick tempered clear glass lens which meets UL requirements.

Standard Equipment Included (All UL Listed)

12 volt LED lamps, housing with trim rings, and transformer with 10’ power cord and switch. Additional fixtures are available. Please submit your requirements.

Lighting Specifications

• Bulb: 12 volt LEDP module 60WH-3020 @ 2.4 Watts each module uses 24PCS of 5MM LEDs
• Color Temp: 6000K White
• Luminous Flux: 150 LM
• Lifespan: Up to 50,000 hours
• Transformer: 120 volt, AC, 12 volt secondary @ 1 amp

Recommended Lighting by Width of Case

• 24": 2
• 30": 3
• 36": 3
• 42": 4
• 48": 4
• 60": 5
• 72": 6

Please contact us for custom case lighting for Peter Pepper Display Cases. Please note that lighting must be installed at the factory and cannot be retrofitted or installed in the field. Lighting cannot be supplied for products by other manufacturers.